CAPE CANAVERAL, Fla. – Several Lead Zirconate Titanate, or PZT, mass gaging sensors have been attached to a composite tank during a test inside a laboratory at the Cryogenics Testbed Facility at NASA's Kennedy Space Center in Florida. The P…
KSC-2014-3645
CAPE CANAVERAL, Fla. – Rudy Werlink, a fluid systems engineer in the Engineering Directorate at NASA's Kennedy Space Center in Florida, monitors a test in a lab at the Cryogenics Testbed Facility using the Lead Zirconate Titanate, or PZT-ba…
KSC-2014-3647
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
Although the new fiber optic sensors on the Ikhana, which are located on fibers that are the diameter of a human hair, are not visible, the sealant used to cover them can be seen in this view from above the left wing. NASA Dryden Flight Res…
ED07-0287-08
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle, left, of Stinger-Ghaffarian Technologies, and other payload team members performs spacewalk tool fit-checks of the integrated Total and Spectral…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle, left, of Stinger-Ghaffarian Technologies performs a sharp edge inspection of the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-1)…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
Technician Marshall MacCready carefully lays a panel of solar cells into place on a wing section of the Helios Prototype flying wing at AeroVironment's Design Development Center in Simi Valley, California. More than 1,800 panels containing…
EC00-0283-5
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig) is a cryogenic test tank developed to evaluate heat intercept concepts. It arrived at Marshall Space Flight Center on August 10, 2017. The tank will receive heat sensor…
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig)
STS046-24-025 (31 July-8 Aug. 1992) --- Astronaut Andrew M. Allen, STS-46 pilot, exercises on the bicycle ergometer device on the flight deck of the Space Shuttle Atlantis as it makes one of its 127 total orbits for the eight-day mission. A…
STS-46 Pilot Allen uses cycle ergometer on OV-104's middeck
KENNEDY SPACE CENTER, FLA. -- Lockheed Martin technicians in the Vehicle Assembly Building at NASA's Kennedy Space Center prepare for the application of new foam over the manhole cover on the lower end of external tank No. 119. The manhole…
KSC-06pd0682
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig) is a cryogenic test tank developed to evaluate heat intercept concepts. It arrived at Marshall Space Flight Center on August 10, 2017. The tank will receive heat sensor…
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig)
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig) is a cryogenic test tank developed to evaluate heat intercept concepts. It arrived at Marshall Space Flight Center on August 10, 2017. The tank will receive heat sensor…
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig)
A rugged, highly accurate, low-temperature sensor is developed by NASA researchers. A new sensor allows accurate, quick low-temperature measurements in rugged environments. This is especially useful in piping with very cold liquids under hi…
Around Marshall
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle, left, of Stinger-Ghaffarian Technologies applies crew preference tape to the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-1) pay…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle, left, of Stinger-Ghaffarian Technologies performs a sharp edge inspection of the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-1)…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
The Helios Prototype aircraft during initial climb-out to the west over the Pacific Ocean.
ED01-0230-2
Altus II aircraft flying over southern California desert
EC98-44684-1
SHIIVER Tank Arrives at NASA’s Marshall Center for Spray-On Foam InsulationSHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig) is a cryogenic test tank developed to evaluate heat intercept concepts. It arrived at Marshal…
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig)
Altus II aircraft flying over southern California desert
EC98-44684-3
Altus II aircraft flying over southern California desert
EC98-44684-2
PATRICK CHAMPEY, (LEFT), DICK GATES, (RIGHT), AND BILL PODGORSKI, (SEATED), ALIGN SUN SENSOR TO HI-C TELESCOPE USING THEODOLITE
SUN SENSOR ALIGNMENT TO HI-C TELESCOPE
An engineer at AeroVironment's Design Development Center in Simi Valley, California, closely inspects a set of silicon solar cells for potential defects. The cells, fabricated by SunPower, Inc., of Sunnyvale, California, are among 64,000 so…
EC00-0283-3
CAPE CANAVERAL, Fla. – Several Lead Zirconate Titanate, or PZT, mass gaging sensors have been attached to a composite tank during a test inside a laboratory at the Cryogenics Testbed Facility at NASA's Kennedy Space Center in Florida. The P…
KSC-2014-3646
Laboratory Researcher suits up for work in a research clean room.  Personal Protective Equipment, PPE, Portait Series
engineers fabricate silicon carbide sensors
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
Tucker Ryan Thomas with G2V takes calibration readings from the OSAM-1 solar simulators during their commissioning tests inside a cleanroom at Goddard Space Flight Center, Greenbelt Md., Oct 3, 2022. This photo has been cleared for public r…
GSFC_20221003_RL_041306
An attendee of NASA's Earth Day event conducts an experiment with circuits. The event took place at Union Station in Washington, DC on April 22, 2014. Photo Credit: (NASA/Aubrey Gemignani)
NASA Earth Day 2014
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle of Stinger-Ghaffarian Technologies performs a sharp edge inspection of the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-1) payloa…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
INSTALLATION OF STRESS SENSORS TO SHELL BUCKLE KNOCKDOWN FACTOR COMPOSITE TANK.
INSTALLATION OF STRESS SENSORS TO SBKF COMPOSITE TANK
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle, center, of Stinger-Ghaffarian Technologies performs a sharp edge inspection of the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle of Stinger-Ghaffarian Technologies performs spacewalk tool fit-checks of the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-1) payl…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
In the high bay of Kennedy Space Center's Space Station Processing Facility, Chris Hardcastle, right, of Stinger-Ghaffarian Technologies performs a sharp edge inspection of the integrated Total and Spectral Solar Irradiance Sensor-1 (TSIS-1…
Total and Spectral Solar Irradiance Sensor (TSIS) EVA Fitchecks
KENNEDY SPACE CENTER, FLA. -- Lockheed Martin technicians in the Vehicle Assembly Building at NASA's Kennedy Space Center apply new foam over the manhole cover on the lower end of external tank No. 119. The manhole was removed to access the…
KSC-06pd0685
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig) is a cryogenic test tank developed to evaluate heat intercept concepts. It arrived at Marshall Space Flight Center on August 10, 2017. The tank will receive heat sensor…
SHIIVER (Structural Heat Intercept Insulation Vibration Evaluation Rig)
KENNEDY SPACE CENTER, FLA. -- Lockheed Martin technicians in the Vehicle Assembly Building at NASA's Kennedy Space Center begin to apply new foam over the manhole cover on the lower end of external tank No. 119. The manhole was removed to a…
KSC-06pd0684
KENNEDY SPACE CENTER, FLA. -- Lockheed Martin technicians in the Vehicle Assembly Building at NASA's Kennedy Space Center prepare for the application of new foam over the manhole cover on the lower end of external tank No. 119. The manhole…
KSC-06pd0683
The European Radiation Sensors Array is one of the first three science payloads selected to fly on the Gateway space station. ERSA will study solar and cosmic radiation to help the science community better understand this primary concern fo…
ERSA 01
Technician Marshall MacCready carefully lays a panel of solar cells into place on a wing section of the Helios Prototype flying wing at AeroVironment's Design Development Center in Simi Valley, California. The bi-facial cells, manufactured…
EC00-0283-4
Mini Impactor Sensors for Lunar Geotechnical Arrays
Mini Impactor Sensors for Lunar Geotechnical Arrays