CAPE CANAVERAL, Fla. -- In the Press Site auditorium at NASA's Kennedy Space Center in Florida, media were briefed about updates to aeronautics research at NASA. Seen here are NASA Public Affairs Officer Beth Dickey, Edgar G. Waggoner, dire…
KSC-2011-5054
4 propeller Tilt Wing. Pictured with Tommy Wills wind tunnel mechanic in the 40x80 foot wind tunnel.
Tilt-Wing/Propeller Model With Blowing Flaps Tested in the 40x80 foot Wind Tunnel at NASA Ames.
Mechanical technician Dan Pitts prepares a scale model of Lockheed Martin's Quiet Supersonic Technology (QueSST) X-plane preliminary design for its first high-speed wind tunnel tests at NASA's Glenn Research Center.
Quiet Supersonic Technology (QueSST)
N+2 Nozzle in the Aero-Acoustic Propulsion Lab. As NASA works toward demonstrating low-sonic boom design, engineers at NASA Glenn have tested an engine nozzle that could make supersonic aircraft much quieter.
N+2 Nozzle Test
A NASA TG-14 sits on the ramp at NASA’s Armstrong Flight Research Center in Edwards, California, on Monday, Aug. 4, 2025, to support NASA’s Quesst mission.
NASA Armstrong TG-14
Acoustic Casing Treatment Testing Completed in the W-8 Single Stage Axial Compressor Facility at NASA Glenn. Four different over-the-rotor acoustic casing treatment concepts were tested along with two baseline configurations. Testing includ…
Acoustic Casing Treatment Test
3/4 Low front view of fuselage and fan. Showing jet engine hanging below. Lift fan powered by jet exhaust.
AC-27149-A. General Aerodynamic Characteristics of a Research Model with High Disk Loading Direct Lifting Fan Mounted in Fuselage.
Installation of the Douglas A-26B airplane in the 40x80 foot wind tunnel at NACA's Ames Research Center. Airplane being centered over tunnel opening.
Douglas A-26B Airplane in Ames 40x80 Wind Tunnel.
Front 3/4 view of the Avrocar mounted on variable height struts in the Ames 40x80 foot wind tunnel, without tail.
Front 3/4 view of the Avrocar.
Publicity Shot of close up of Nacell, Drive Nacel and cooling vent in nose for wind tunnel in NACA Ames 40x80 foot Wind Tunnel.
Nacelles and props in 40x80 foot wind tunnel at Ames.
Horizontal view (side) of model, Ray Schmoranc in photo. Test #452
Semispan Airframe noise test in the 40x80 foot wind tunnel.
3/4 front view from below of the Ryan FR-1 airplane mounted in the NACA Ames 40x80 foot wind tunnel. Production configuration.
Ryan FR-1 in NACA Ames 40x80 foot Wind Tunnel.
Test No. 175  Kaman K-16 in 40x80 Foot Wind Tunnel at Ames Research Center.  Kaman K-16B was an experimental tilt wing aircraft, it used the fuselage of a JRF-5 and was powered by two General Electric YT58-GE-2A engines.
Kaman K-16 in 40x80 Foot Wind Tunnel at Ames Research Center.
NACA Ames 40x80 foot wind tunnel (South West).
NACA Ames Laboratory Building, South West.
Rear view of the Avrocar without the tail, with ground board and variable height struts. The air force wanted to test the design of a flying saucer with vertical takeoff and landing capability. The design proved unstable without the tail.
Tests Of Avrocar Annular Jet VTOL Airplane in Ames 40x80 foot Wind Tunnel.
AirVenture at Oshkosh 2023
AirVenture at Oshkosh 2023
40x80 wind tunnel manometers control room at NACA's Ames Research Center.  Control panel (called the bench board) showing five of the seven scale heads which measured the forces on the model (ie. Lift, drag, side force etc.)
A-15219. Balance House for the 40x80-foot Wind Tunnel Control Room.
AirVenture at Oshkosh 2023
AirVenture at Oshkosh 2023
Color view of the Avrocar from overhead in the 40x80 wind tunnel, without A1:H73 mounted on variable height struts.
Overhead View of Avrocar in Ames 40x80 foot Wind Tunnel.
The Marshall Space Flight Center was activated on July 1, 1960 as a part of NASA, which had been established on October 1, 1958 by Congressional passage of the National Aeronautics and Space Act. The nucleus of NASA was the Advisory Committ…
Origin of Marshall Space Flight Center (MSFC)
Wide shot of 40x 80 wind tunnel settling chamber with Lockheed XFV-1 model.  Project engineer Mark Kelly (not shown). Remote controlled model flown in the settling chamber of the 40x80 wind tunnel. Electric motors in the model, controlled t…
Lockheed XFV-1 model in the 40x80 foot wind tunnel at NASA Ames Research Center
Research engineer, Harry Henninger of the Ryan Aeronautical Company, with the deflected slipstream model VZ-3RY Vertiplane.
Ryan VZ-3 Vertiplane #92.
In the Kennedy Space Center's Press Site auditorium, Matthew Kamlet of NASA Communications at the Armstrong Flight Research Center in California, speaks to members of the media at a news conference to discuss upcoming flight tests to study…
SonicBAT News Conference
(Test 460) deHavilland Augmentor Wing 40x80 Foot Wind Tunnel.
deHavilland Augmentor Wing 40x80 Foot Wind Tunnel Test 460
Rear view of the Avrocar with tail, mounted on variable height struts.  Overhead doors of the wind tunnel test section open. The first Avrocar, S/N 58-7055 (marked AV-7055), after tethered testing, became the "wind tunnel" test model at NAS…
Avrocar Test in Ames 40x80 Foot Wind Tunnel.
Acoustic Casing Treatment Testing Completed in the W-8 Single Stage Axial Compressor Facility at NASA Glenn. Four different over-the-rotor acoustic casing treatment concepts were tested along with two baseline configurations. Testing includ…
Acoustic Casing Treatment Test
In the Kennedy Space Center's Press Site auditorium, Peter Coen, SonicBAT Mission Analysis at NASA’s Langley Research Center in Virginia, speaks to members of the media at a news conference to discuss upcoming flight tests to study the effe…
SonicBAT News Conference
NASA Glenn Mechanic Thomas Thompson checks the nose wheel axle nut on NASA Glenn’s Learjet 25 research aircraft.
Learjet 25 Research Aircraft
Top front view of Delta wing lift fan fighter model.
Lift-Fan Delta Wing Fighter Model in Ames 40x80 foot Wind Tunnel.
Lift engine VSTOL fighter model, 3/4 lower front view showing jet engines exit vanes.  Yarn tufts attached to horizontal tail.
VSTOL Lift-Engine Fighter Model in Ames 40x80 foot Wind Tunnel.
3/4 front view of Avrocar without tail, showing ground board and variable height struts.  The ground board minimizes the boundary layer on the floor under the model.   black and white negative: KODAK T-MAX 100 Professional. SBA settings neu…
40X80 foot Wind Tunnel Tests Of Avrocar Annular Jet VTOL Airplane.
A chambered and twisted wing-body. Arrow wing hypersonic model tested in the 6x6 foot wind tunnel at the NASA Ames Research Center.
Arrow Wing Model in the 6x6 Foot Wind Tunnel at NASA Ames.
AirVenture at Oshkosh 2024
AirVenture at Oshkosh 2024
Forward overhead view of 4 jet model with external flow of jet augmented triple slotted flap. John Bouldt
Jet Augmented Flap, Triple-Slotted.
AIAA students with Chris Scolese on July 24, 2018
GSFC_20180724_2018-4933_006
6x6 wind tunnel test on the effects of wing sweep.
SWEPT-BACK WING. MODEL IN 6X6' W.T.
N+2 Nozzle in the Aero-Acoustic Propulsion Lab. As NASA works toward demonstrating low-sonic boom design, engineers at NASA Glenn have tested an engine nozzle that could make supersonic aircraft much quieter.
N + 2 Nozzle Test
A NASA ER-2 aircraft takes off from NASA’s Armstrong Flight Research Center in Edwards, California, on Tuesday, March 31, 2026, to support the Geological Earth Mapping Experiment (GEMx) airborne science mission.
NASA Armstrong ER-2
AirVenture at Oshkosh 2024
AirVenture at Oshkosh 2024
The Advanced Noise Control Fan shown here is located in NASA Glenn’s Aero-Acoustic Propulsion Laboratory. The 4-foot diameter fan is used to evaluate innovate aircraft engine noise reduction concepts less expensively and more quickly.
Advanced Noise Control Fan (ANCF)
3/4 view of model in cruise configuration with 25 deg. Sweep, AR=6.9. SCAT-16; Variable Sweep Model in 40x80 Wind Tunnel at NASA Ames.
SCAT-16; Variable Sweep Model in 40x80 Wind Tunnel at NASA Ames.
Space Shuttle SSV Orbiter Model A100 0.36 Scale In 40x80 Foot Wind Tunnel. 3/4 lower rear view.
Space Shuttle SSV Orbiter Model In 40x80 Foot Wind Tunnel.
Avrocar in the shop of the 40x80 foot wind tunnel with the 4 prop tilt wing model in the back ground.
Avrocar in the shop of the 40x80 foot wind tunnel.
In the Kennedy Space Center's Press Site auditorium, NASA and other government leaders speak to members of the media at a news conference to discuss upcoming flight tests to study the effects of sonic booms. Participants from left are: Matt…
SonicBAT News Conference
In the Kennedy Space Center's Press Site auditorium, Dale Ketcham chief of Strategic Alliances for Space Florida, speaks to members of the media at a news conference to discuss upcoming flight tests to study the effects of sonic booms. Kenn…
SonicBAT News Conference
(03/12/1943) Aerial view of the site from the 40x80 wind tunnel At NASA Ames Research Center. Site includes the 16 foot and 7x10 wind tunnels in the background.  Building 200 also under construction.  Framing for the drive fans of the 40x80…
Aerial View Of The Site From The 40x80 Foot Wind Tunnel At Nasa Ames Research Center.
3/4 lower rear view of Controllable Twist Rotor (CTR) test of 4 blade helicopter model. Pictures with Ben Mandwyler Andy Lemnios, in 40x80 foot wind tunnel. Small flaps on rotor blades.
Controllable Twist Rotor in 40x80 Foot Wind Tunnel at Ames.
The Plasma Spray-Physical Vapor Deposition (PS-PVD) Rig at NASA Glenn Research Center. The rig helps develop coatings for next-generation aircraft turbine components and create more efficient engines.
Vapor Deposition Rig